| Chain Making |
|
1. Getting Started.
|
|
|
2. Making the assembly tool: put screws and 1mm solder lines.
|
|
|
3. Squeeze the ends of solder line by pilers.
|
|
|
4. Place the part 3 onto the assembly tool, starting from position b (not a) to position v.
|
|
|
5. Put the tool 1.
|
|
|
6. Cut off part A and B, don't mix up A and B.
|
|
|
7. Put part A first then B.
|
|
|
8. Using adhesive for paper.
|
|
|
9. Apply to the parts for temporary fixing.
|
|
|
10. Put the tool 5, 6 and 7. Also the part B as shown.
|
|
|
11. Put the part 30 and 31.
|
|
|
12. Use a small hammer to strike part 3 with light force. Striking gently with patience is the key. Use a flat metal base to support. If no metal base found, use the surface of the piler as base instead.
|
|
|
13. It should be no gap after striking.
|
|
|
14. Take away part 30 and 31.
|
|
|
15. Take away the assembly tool to get the assmebled chain segment.
|
|
|
16. Put the part 3 at the end of the chain.
|
|
|
17. Repeat the steps 4 to 15 to make other segments.
|
|
|
18. Connect the segments with masking tape.
|
|
|
19. Use a small hammer to strike the part 3.
|
|
|
20. Connect all the segments as step 18 and 19.
|
|
|
21. Put the assmebled chain to the engine and wheel, then drill a 2mm hole for adding the axle.
|
|
当前位置: 
迷你购物车:
;)
;)
